Futaba 14MZ Manual do Utilizador descarregar pdf (Página 95)

Trim Mix 1/2

[Corresponding model type]: Glider, 2 ailerons or more

These functions call the ailerons, elevators, and

ﬂ aps (camber ﬂ aps, brake ﬂ aps) trim offset rates

preset according to the ﬂ ight state.

The amount of ailerons, elevator, and flaps

(camber ﬂ ap, brake ﬂ ap) trim offset can be set to

a switch.

As an example Trim Mix 1 can be set up for

launching, with speed ﬂ aps and ailerons dropped,

and a slight amount of up elevator. Trim mix

2 can be used for high speed flying, with both

ailerons and speed ﬂ aps reﬂ exed slightly, and a bit

of down elevator.

The trim functions can be activated during

ﬂ ight by setting a switch. To prevent sudden trim

changes when switching ﬂ ight conditions, a delay

can be set to provide a smooth transition between

the two. Trim Mix 2 will have priority over Trim

Mix 1.

●Return to Model Menu

● When a ﬁ ne tuning VR is set on the next page (2/2), the ailerons

and ﬂ aps trim rates can be adjusted.

Touch the corresponding button and adjust the rate with the

adjustment buttons displayed on the screen.

● The ailerons, flaps, and elevators

offset rate can be adjusted.

Touch the corresponding button

and adjust the rate with the

adjustment buttons displayed on

the screen.

● Touch the [Trim Mix 1] button in the Model Menu to

call the setup screen shown below.

(The display screen is an example. The actual screen depends on the

model type. The screen shown below is for 4 ailerons and 4 ﬂ aps.)

(Touch the [1/2] button to switch to page 2.)

● Touch the ACT button and set the function to ACT

(ON).

● When setting a switch, touch the Switch button

to call the <Switch> screen, and then select the

switch and set its ON direction. (Always ON at "NULL"

setting)

(For a description of the switch selection method, see the description at

the back of this manual.)

Example

1. Touch the ACT button and set the trim mix function

to [ON].

*When separating the settings for each condition, touch the

group mode button and set it to [Sngl].

2. Select the ON/OFF switch.

3. Select the [Manual] or [Auto] mode.

In the [Auto] mode, also select an auto SW. This

switch can be linked to a stick, etc.

<Speed>

In: The operation speed at switch ON can be set.

Out: The return speed at switch OFF can be set.

The offset rate can be varied in the Fine Tuning

numeric range set at screen [1/2] by VR, etc.

selection.

When ﬂ ight conditions are set, the operation speed

can be set for each condition. Condition delay

operation can be interrupted and each rudder

quickly returned to its original position by selecting a

cut switch.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 126 127

Comentários a estes Manuais

Sem comentários

Futaba 14MZ Manual do Utilizador Página 95

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios de comunicações Futaba 14MZ