Futaba 14MZ Manual do Utilizador descarregar pdf (Página 65)

●Return to Linkage Menu

● Touch the [Throttle Cut] button in the Linkage Menu

to call the setup screen shown below.

Throttle Cut

Stops the engine safely and easily.(airplane and helicopter only)

(The display screen is an example. The screen depends on the model type.)

Throttle cut provides an easy way to stop the

engine, by ﬂ ipping a switch with the throttle stick

at idle. The action is not functional at high throttle

to avoid accidental dead sticks. The switch’s

location and direction must be chosen, as it defaults

to NULL.

Throttle cut setting procedure

1. Touch the "INH" button to activate the

Throttle Cut function.

2. Throttle cut function switch setting:

Touch the "NULL" button to call the <Switch>

screen, and then select the switch and its ON

direction.

(For a detailed description of the selection

method, see [Switch Setting Method] at the

back of this manual.)

3. Throttle cut position setting:

Set the throttle stick to maximum slow, and

touch the Cut Position button. Adjustment

buttons appear. At the same time, the

numerical value of the current maximum

slow side is displayed at "Cut Position".

Use the adjustment buttons to adjust the

servo travel when the throttle cut function is

activated.

●Initial value: 17%

●Adjustment range: 0%~50%

*With throttle stick at idle, adjust the rate until the engine

consistently shuts off, but throttle linkage is not binding.

When ﬁ nished, touch the “Throttle Cut” button to exit.

To exit the setting, touch the [Throttle Cut]

button.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 126 127

Sem comentários

Futaba 14MZ Manual do Utilizador Página 65