Futaba 14MZ Manual do Utilizador descarregar pdf (Página 108)

PIT Curve/Pitch Trim

PIT Curve

This function adjusts the pitch operation curve

for each ﬂ ight condition for the optimal ﬂ ight state

relative to movement of the throttle stick.

The pitch curve can be freely selected from linear operation

curve to smooth curve, and adjusted to match the curve

you want by means of the T14MZʼs powerful Curve Edit

Function (6 types of curves can be selected). Up to 17 points

can be set for linear or curve types. However, when using

the 3 points or 5 points speciﬁ ed to create a curve, a simple

and smooth curve can be created by selecting the curve type

and reducing the number of input points to 3 or 5, and then

entering the specified value at the corresponding points

that you created.a curve, a simple and smooth curve can be

created by selecting the curve type and reducing the number

of input points to 3 or 5, and then entering the specified

value at the corresponding points that you created.

● Return to Model Menu

● Touch the [PIT Curve] button in the Model Menu to

call the setup screen shown below.

● There are 4 types of display. The curve of all the

conditions or the pitch and throttle curves can be

displayed on one screen.

● Linear type is 9 points, but for

simple use, 4~5 points are

sufﬁ cient.

● Normally use Separate.

● Trim can be used

as hovering pitch

and pitch trim.

The high and low

side pitch can

be ﬁ ne-tuned.

● Units can be selected from [%] and [Deg]. When [Deg] is

selected, the rotor pitch angle is displayed and becomes the

setting standard. When [Deg] was selected, the high, center,

and low pitch angles are enterd.

● Can be copied to the pitch trim adjustment position.

● When the [Angle] button is touched, the pitch angle input

screen is displayed. Input the maximum pitch, center, and low

pitch.

Normal curve adjustment

● For normal curve, usually use [Line] type and

create a basic pitch curve centered about

hovering. Use this function together with the

THR Curve (Normal) function and adjust the

curve so that up/down control is best at a

constant engine speed.

Idle up curve adjustment

● For the high side pitch curve, set the

maximum pitch which does not apply a

load to the engine. For the low side pitch

curve, create curves matched to loop, roll,

3D, and other purposes and use the idle up

curves according to the performance.

Note: When the curve type is changed, the data is

reset.

Throttle hold curve adjustment

● The throttle hold curve is used when

executing auto rotation dives.

Operation precautions

WARNING

When actually starting the engine and

flying, always set the idle up condition

switch to [OFF] and start the engine in the

idling state.

108

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 126 127

Comentários a estes Manuais

Sem comentários

Futaba 14MZ Manual do Utilizador Página 108

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios de comunicações Futaba 14MZ