Futaba 14MZ Manual do Utilizador descarregar pdf (Página 117)

PIT to Needle mixing

This mixing is used when the engine is equipped

with needle control or other fuel-air mixture

adjustment. A needle curve can be set.

An acceleration function which temporarily

increases needle operation at throttle stick

acceleration/deceleration operation can be set.

The rise characteristic of the needle servo at

acceleration and deceleration operation can be

adjusted.

● Return to Model Menu

● Touch the [PIT to Needle] button in the Model

Menu to call the setup screen shown below.

Setting method

●When using this function, touch the [INH] button

and display [ON] or [OFF].

●When you want to set the same contents at other

conditions, select the group mode (Gr.). When

you want to set the selected condition only, select

the single mode (Sngl).

●A needle curve can be set.

●A switch can be set.

When [NULL] is set, the function is operated by

merely selecting the condition.

When setting and [ON]/[OFF] switch, touch the

[NULL] button and set the switch and its ON

direction at the <Switch> screen.

< Acceleration function setting>

●Acceleration can be set at both setting

at acceleration (High) and setting at

deceleration (Low).

●The acceleration rate (Rate) and the return

time after operation (Dump.) can be set.

●An operation point (Operation Point) at

acceleration and deceleration can be set.

When an operation point was exceeded,

acceleration operation is performed.

● Normally, use [Line] type.

117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 126 127

Sem comentários

Futaba 14MZ Manual do Utilizador Página 117